Trending Products UV Light Water Purifier - Medium Pressure UV Sterilizer – Guanyu

Characteristics Of The Equipment

Medium pressure ultraviolet lamp tube: using medium pressure high quality imported lightsources from the United States, high power, reduce the number of lamp tube configuration, can handle large flow water. Compared with the low pressure ultraviolet lamp tube, the ultraviolet ray intensity is big, the radiation ray wavelength is wide.

Temperature probe: immediately detect the temperature of water to ensure that the equipment operates at the operating temperature of 0~45 degrees.

Temperature probe: immediately detect the temperature of water to ensure that the equipment operates at the operating temperature of 0~45 degrees.

Quartz tube: in order to better protect the ultraviolet lamp tube, each ultraviolet lamp tube will have a quartz tube outside. Therefore, the quality of the quartz sleeve largely determines the sterilization effect of the uvb sterilizer. The high-quality quartz sleeve can ensure the uv penetration rate of more than 90%.

Daily cleaning: due to the irradiation of water quality and ultraviolet light, the surface of the quartz casing will crystallize after a period of use. If the thickness of the crystal reaches a certain degree, the penetration ratio of ultraviolet ray will be affected. Therefore, the quartz casing needs to be cleaned regularly. The medium pressure uv sterilizer is equipped with an automatic cleaning system, which can automatically clean the quartz sleeve according to the reading of the uv intensity detector. During the cleaning process, the system runs normally without water cut or manual participation, which greatly reduces the workload of field personnel.

Technology Parameter

Equipment Installation Schematic Diagram

Common Troubleshooting Methods

Influent Quality

(drinking water) water inlet requirements

(sewage) inlet water requirement index

Routine Inspection And Testing

● every 4-5 weeks after the use of the equipment, the equipment should be checked, pay attention to the following abnormal conditions

● the power cord or plug is unusually hot with a burning smell.

● welding part of the pipe, the interface part, whether the two ends of the quartz pipe leak.

● control cabinet indicator light, lamp tube is normally lit.

● low sterilization efficiency.

● other abnormal faults.

In case of any of the above situations, stop using the equipment to prevent accidents. Be sure to follow “common troubleshooting methods” to troubleshoot. If the troubleshooting still cannot be eliminated, please contact our company and its agents and resellers.

Note: blue, green and yellow colors at both ends of the tube are normal phenomena.